Shenzhen Just Motion Control electromechanics co., ltd
0755-26509689
sweep torque
P08-51
amplitude
Setting range:1-300
sweep torque amplitude
C. Use the auxiliary function to identify the resonant frequency and set the trap parameters during machine
operation
The auxiliary function of the driver can be used to identify the vibration frequency and set the parameters of
the trap. The difference from the function of the previous point is that in the B item, when the mechanical off is
enabled, the driver itself is excited to identify the resonance. Item C refers to the occurrence of resonance during
normal operation of the machine, and identify the frequency. Use steps:
a) Confirm whether the first trap and the second trap allow setting. This can be determined by looking at
parameter P08-24. if both that first trap and the second trap are enable. then the parameters of the first or second trap
need to be set to the third trap and the correspondingP 08-24. 0/1 is set to0. This means that the first/second trap can
be reset.
b)Then perform auxiliary functionF22
c) After the F22 auxiliary function has been performed, the drive enters the frequency identification state for
10 s. During this time, the device is operated, and when a resonance point occurs, the driver will recognize it and
display it on theLED. The sensitivity of frequency identification depends on parametersP02-51, P02-52.
d) If the frequency identification is correct, press and hold the Enter key, the driver will automatically set the
current frequency parameter to the first/second trap, and set the corresponding P 08-24.0/1 to 1 to start the trap.
Related parameters
Param
Code
Name
Note:
Vibration
P02- 51 detection
Setting range: 50-500
sensitivity
Setting range: 0-5000
Vibration
P02- 52
detection level
This parameter sets the vibration detection sensitivity of the adaptive notch
filter. The smaller the parameter value, the more sensitive the detection
sensitivity is
D. Manually set trap parameters
73
