Shenzhen Just Motion Control electromechanics co., ltd

0755-26509689

F11.Err

F12.clr

F13.unL

F14. out

Fault log shows

Alarm record

clearing

Operation

authority setting

Force output port

level

press theENT key to enter

2. Select the parameter range to be restored: input the corresponding code

according to the following table, and select the parameter range to be

restored. Press and hold theENT keyuntil a progress bar appears untilfinsh

flashes, completing the factory reset.

Code

implication

51

Restore Level 1 Privilege Parameters (Application

Parameters)

52

Restore level 2 privilege parameters (application

parameters + motor parameters)

55

Restore all parameters (including hidden parameters)

1. Press theM keyon the operation panel to switch to the auxiliary

modeF**, operate theUp/Down key toF11.Err, and press theENT key to

display the past 8 times of historical fault information. The number on the

left is F 0, which represents the most recent failure

2. Press the Up keyto display past faults one by one. PressENT key for

along timeto display the fault occurrence time. Refer to d25.tiE for time

coordinate.

3. Press theM key to exit the mode.

Note:The fault occurred during multiple power-up and power-down within

30 minutes may have a 30-minute deviation in its recording time.

1. Press theM keyof the operation panel to switch to the auxiliary

modeF**, operate theUp/Down key toF12.clr, press theENT key, the

panel displaysclr.Er, and press theENT key to clear the alarm information

recorded inF11.Err.

2. Press theM key to exit the mode.

1. Press theM keyof the operation panel to switch to the auxiliary

modeF**, operate theUp/Down key toF13.unL, and press theENT key to

edit the operation authority. 0: Parameters cannot be modified;1:

Parameters can be modified (except system parameters); 2: All visible

parameters can be modified; Set the value of 0,1, and save when power is

off. When setting 2, it will not be saved after power failure.

2. Press theM key to exit the mode.

1. Press the M key of the operation panel to switch to the auxiliary mode

F**, and operate the Up/Down key to F14. out, press ENT key to force

output port level through Up/Down key. The corresponding relation with

the output port is that the four vertical bars of the operation panel from right

151