Shenzhen Just Motion Control electromechanics co., ltd

0755-26509689

P00-34

P00-35

P00-39

P00-40

P00-41

P00-42

P00-43

P00-44

Resistance of built-in

braking resistor

heat dissipation

coefficient of

resistance

Three-phase power

0

input selection

Electrical signal

1

shielding on RST

Temperature

Compensation

Settings

Overtemperature

alarm setting

Overtemperature

warning setting

Fan startup

temperature setting

0 Fan Fault Settings

Communication with

1 FPGA abnormal fault

setting (E.052)

Setting range: 1-65535, unit: 0.1 ohm

Set correctly according to the value of the built-in braking resistor

Setting range: 1-100, unit: %

Set reasonably according to the heat dissipation conditions of the resistor.

If the heat dissipation conditions are good, the value can be set

appropriately. When the setting value is large, the allowable energy of

resistor regeneration increases, and it is not easy to report regeneration

overload.

Setting range: 0-1

0: Single power input

1: Three-phase power input (phase loss alarm AL400 will be generated

when phase loss occurs)

Setting range: 0-1

0: power-on judgment signal for normal use

1: shield power-on signal

Setting range: -20-20, unit: degree centigrade

Correction of deviation of d24.Ath from actual temperature by parameter

value

Setting range: 1-150, unit: degree centigrade

Alarm when radiator temperature reaches set value E.440

Setting range: 1-150, unit: degree centigrade

Overtemperature warning when radiator temperature reaches set value

Setting range: 1-150, unit: degree centigrade

The fan starts when the radiator temperature reaches the set value

Setting range: 0-1

0: Close fault

1: Fault allowed

Setting range: 0-1

0: Close fault

1: Fault allowed

Regeneration

2 abnormal alarm

(E.430)

Setting range: 0-1

0: Close fault

1: Fault allowed

115