Shenzhen Just Motion Control electromechanics co., ltd

0755-26509689

F17.rES

F18.PJG

F19.J-L

F21.Fft

software reset

Program JOG

Load inertia ratio

measurement

Identification of

resonant

frequency

(commanded

internally in the

driver)

to left respectively correspond to DO1-DO4

2. Press theM key to exit the mode.

1. Press theM keyof the operation panel to switch to the auxiliary

modeF**, operate theUp/Down key toF17.rES, press theENT key, the

panel displays rESEt, and press theENT key to perform software reset.

2. Press theM key to exit the mode.

1. Press the M key on the operation panel to switch to the auxiliary mode

F**, operate the Up/Down key to F18.PJG, and press the ENT key to

execute the program J OG function.

2. Press theUP key orDOWN key, and the motor will operate according to

the operating conditions set in P08-06~ P08-12.

3. Press theM key to exit the mode.

Note: this mode can only be operated underrdy, otherwise the driver

will alarm A.905

1. Press theM keyof the operation panel to switch to the auxiliary

modeF**, operate theUp/Down key toF19.J-L, press theENT key to enter

the load inertia measurement function, the panel displays 1.00, and

pressthe ENT key for a long time, the panel displays-1.00

2. Press theUP key, the motor will run back and forth according to the

number of turns set by P08-02, the maximum speed set by P08-03, the

acceleration and deceleration time set by P08-04 and the waiting time set

by P08-05, until the flashing load inertia ratio appears.

3. Press ent to save directly to P01-04, or record the value to exit and write

to parameter P01-04

4. Press theM key to exit the mode

Note: this mode can only be operated underrdy, otherwise the driver

will alarm A.905

1. Press the M key of the operation panel to switch to the auxiliary mode

F**, and operate the Up/Down key to F21. Fft, press ENT key to identify

resonance frequency (command is sent from driver); Long press ENT key

panel display-F.00, press UP or DOWN key, the driver will automatically

detect the resonance frequency, the number is the frequency

2. Pressing ent will save directly to P08-30, or record the value to exit and

write to parameter P08-30

3. Press theM key to exit the mode

Note: this mode can only be operated underrdy, otherwise the driver

will alarm A.905

152