Specialized Concentrated Focused
WARNING
accordance with specifications set forth in the manual, or it may result in breakdowns such
as short circuit and permanent damage to the device;
To guard against electric shock or CNC device damage, fingers should keep dry before
plugging or touching switch; The connecting wire should not be damaged and squeezed,
or the leakage or short circuit may occur;
It is prohibited to plug or open the chassis of CNC device when power on.
4) Precautions Related to Running & Debugging
Parameters setting should be checked before running, since wrong setting may lead to
accidental movements;
Modification to parameters should be within the allowable range, or such breakdowns as
unsteady running and machine damage will occur.
5) Precautions in Use
Before power-on, please make sure that the switch is on blackout to avoid occasional
start-up;
Please check the electromagnetic compatibility during electrical design in order to avoid or
reduce electromagnetic interference to the CNC device. A low pass filter should be
employed to reduce electromagnetic interference if there are other electrical devices
nearby;
It is not allowed to frequently power on and power off. It is recommended to power up the
machine again at least one (1) minute later after power failure or blackout.
CAUTION
1) Precautions Related to Product and Manual
Matters related to restrictions and functions available stipulated in the manuals issued by
the machine manufacturer are prior to those in this manual;
This manual assumes all the optional functions are available, which you must confirm
through manuals issued by the machine manufacturer;
Please refer to manuals issued by the machine manufacturer for the instructions of
「IV」Preface
