Specialized Concentrated Focused
“SOff at Pause”. Whether the spindle stops or not, at this time, the three axes can be jiggled. Each
press of an axis direction key will make the corresponding axis move a specified step.
The operation steps as follows:
1) Press
in the process of machining, and then press
+
to enter the jiggle
page.
2) Press “↑” or “↓” to select a step size from “0.01”, “0.02”, “0.05”, “0.10”, “0.20”, “0.50” and “1.00”.
3) Press one of “4”, “6”, “2”, “8”, “3” and “9” to execute jiggle on desired axis in corresponding
direction.
4) Press “Start” to resume machining after jiggle.
CAUTION
If hard limit, soft limit or E-stop occurs in jiggle, the system will stop jiggle, give a limit prompt or an alarm,
and return to the main page.
5.8.4. Continuing Machining after Pause
When the system is in the state of pause, pressing the start key
will continue machining
from the pause position, running status at the top right corner of the screen changing from “Pause” to
“Run”; at the same time, the machine tool continues machining.
5.8.5. Soft Limit Handling
Soft limit occurs when an axis exceeds the setting range of “MachineStroke” during machining,
and the system will display a limit dialog as shown below.
X Soft Limit
OK
ESC
Fig. 5-16 Soft limit dialog
Press [OK] or [ESC] to exit from this warning dialog and return to the machining page, and then
manually move the limit axis towards the reverse direction to release limit. After soft limit occurs, the
system prohibits the limit axis from moving towards the limit direction.
「36」Machine Tool Debugging
    "