73 CypCut Laser Cutting Control System
Adjust low pass filter frequency as high as possible without affecting the accuracy. It requires
both of before corner and after corner do not generate waves when cutting a rectangle, polygon and
starbursts. It can be set according to the following experienced table. Or adjust the low-pass filter
frequency within the upper and lower two ranges after determining cut acceleration. The parameters
of cut acceleration and low-pass filter frequency must be matched. Please do not adjust one parameter
value very large and another parameter value very small.
Level
1 2 3 4 5 6 7 8
Cut
0.1 0.2 0.3 0.4 0.5 0.6 0.8 1
acceleratio
n (G)
Filter
3 3.5 4 5 5.5 6 6 6
frequency
(HZ)
9 10
1.5 2
7 8
6.5.5 Set circle and corner precision
It’s not recommended users modify these two parameters of circle and corner precision under
normal circumstances. Under special circumstances, you can fine-tune these two parameters in the
vicinity of the default parameters range.
If you are not satisfied with the circle precision, you can tune the parameter of circle precision
down, with limiting the speed of cutting circle. The smaller the value is, the more obvious the speed
will be limited. If you are not satisfied with the corner precision, you can tune the parameter of corner
precision down. And then turning will slow down, The smaller the value is, the more obvious the
corner will slow down. The higher the value is, the closer the corner will be to a fillet.
