CypCut Laser Cutting Control System
8
they include setting lead lines, setting compensation and so on. Big size button “
” can be used
to set lead lines, and the button “
” is used to set lead seal over, lead seal gap or lead seal
parameters. The button “”
is used for cutting compensation; the
button“
” can insert micro joint of not cutting into the graphics; the button
“
” can reverse a single graph; and the button "
" is for setting a cooling point
in the graph. Clicking the button“
” and then clicking the position where you hope to set
as the start of the graphics, you can change the start of the graphics; if you click outside the graphics,
and then click on it again, you can draw a lead manually.
You can press Ctrl+A to select all the graphics as quick start tutorial, then click the button “Lead”
and set the parameters of the lead lines, and then click OK. In this way the software can search
suitable positions to add the lead automatically according to your settings. You can conduct the Lead
Lines Check by clicking the small triangle below the button “Lead” and selecting “Check lead lines”.
When select “Distinguish inner and outer mold”, lead can be automatically optimized according to
inter and outer mold.
You can set detailed cutting technical parameters by clicking the button “ ” in the toolbar at
the right. The dialog box “Layer Parameter Settings” contains almost all the parameters related to the
cutting effect.
1.4.4 Lead Planning
In this step the graphics will be sorted as required. You can conduct automatic sorting by
clicking the button “
” under the “Home” or “Nest” menu, while you can select the ways of
sorting and control whether it is allowed to change the direction of the graphics and automatically
distinguish inner and outer mold during the automatic sorting by clicking the small triangle under the
button,.
If the automatic sorting cannot meet the requirements, you can click the button“ ” in the
toolbar at the left to enter the manual sorting mode, and click the graphics with mouse one by one,
and in this way you can set the working order . You can specify the order between these two graphics
through pressing the mouse and drawing a line from one graph to another.
