CypCut Laser Cutting Control System
70
recommended use L model (Effective when light is on).
If workbench has high and low height, please select "Separate seeking height for workbench".
6.4.3 One point edge seek Instructions
Take down side edge seek for an example:
① Coarse positioning outside the plate.
② Coarse positioning inside the plate.
③ Fine positioning outside the plate.
④ Move to plate margin.
6.4.4 Three point edge seek Instructions
1) The offset value between photoelectric switch and laser cutting head must be measured, when
three-point edge seek is firstly used;
2) The cutting head (ie, red light produced by lasers, rather than the photoelectric switch) moves
inside the plate near the lower right region, to determine the initial position of the edge seek;
    "