CypCut Laser Cutting Control System
36
Note: Different options may be displayed in the dialog “Layer Parameter Setting” due to different
lasers, different gas pipeline configurations and different followers. The above figure is only used for
reference, and the actual contents displayed in your software shall be taken as the criterion.
3.11.1 Descriptions of Parameters
The brief descriptions of some parameters in the layers are as follows.
① Basic Parameters
Cut Speed
Set the actual target speed of cutting. There are acceleration and
deceleration at the first and last sections as well as the corners of
cutting track, so the actual cutting speed is often less than the speed.
Lift Height
Set the lift height of laser head after cutting a segment of curve.
Z-axis will lift to a certain height after suspending the cutting, and
the height is lift height.
② Cutting mode
Standard
Cutting according to set standard parameters.
Fixed Height Cut
Cutting with fixing laser head at a certain height.
Extra-plate follow
When you select the mode, the knife point can be docked off the
board. During actual cutting, portion of the laser head outside the
