CypCut Laser Cutting Control System
68
position of the edge seek;
2) Select "Down right" under "Three-point edge seek 'drop-down menu.
3) The software automatically determines the A and B points based on the initial position, the
plate length, plate width and rack position
4) Move to point A;
5) Seek the first point X1 thorough Y negative direction;
6) Move to point B;
7) Seek the second point X2 thorough Y negative direction;
8) Move to point A;
9) Seek the third point Y1 thorough X positive direction;
10) After completing edge seek, calculate the rotation angle θ, determine vertex O on the lower
right of plate and move to vertex O. The edge seek results will be displayed in yellow font on the
upper right of software.
6.3.4 Precautions of BCS100 edge seek
1) Before edge seek, have to return to the starting point to correct machine coordinate system
2) Make sure that the actual number of pulses sent by diagnostic interface must be consistent
with the number of encoder feedback. If inconsistent, please modify the servo parameters.
3) The setting value of plate length and width should be consistent with the actual value.
4) Inclination angle of plate should not exceed 10 degrees.
5) The direction of edge seek in BCS100 edge seek interface can be arbitrarily set. But in actual
use of BCS100 edge seek function, you must set stopping point as upper left, lower left, upper right
and lower right, to determine the direction of edge seek.
6) Before edge seek, please make sure the cutting head moves inside the plate as the starting
position of edge seek.
7) Before edge seek, please make sure the cutting head can properly follow.
6.4 Infared edge seek operating instructions
The CypCut version after 6.3.642.6 improves the function of infared edge seek. Infared edge seek
function should be used with OMRON photoelectric switch of E3Z-L61 model.
    "