CypCut Laser Cutting Control System
56
“Infared Edge seeking” needs to set some parameters. Coarse positioning speed is the speed of
coarse positioning during edge seek, and recommended value is 100mm/s. Fine positioning speed is
the speed of fine positioning during edge seek, which will affect the accuracy of edge seek,
recommending setting value as 10mm / s without exceeding 30mm / s. The smaller the fine positioning
speed is, the longer the time of edge seek is and the higher positioning accuracy is. Plate size and
correction value is similar to "BCS100 edge seek".
The deviation between the photoelectric switch and the laser head can be corrected by setting
advanced parameters and filtering rack interference.
You can set the following parameters: “Offset value" is the deviation between photoelectric
switch and the laser head position. After setting the "deviation between photoelectric switch and the
    "