CypCut Laser Cutting Control System
22
3.1.5 Lead Seal, Gap and Over
There are three buttons, as
, in “Technical Design” under “Home” menu, which are
used to set lead seal, gap and over. Please select the graphics you need to set, and then click the
corresponding buttons. The size set of “Gap” or “Over” can only be valid when resetting gaps or over
cut later, and the size which has been set before will remain unchanged.
3.2 Cutting Compensation
Please select the graphics to be compensated, and then click the button “
” on the
toolbar for cutting compensation.
The cutting width will be obtained in accordance with the actual cutting results. The
compensated track will be shown in white on the drawing board and the system will run along the
compensated track during processing. The compensated original drawing will not be processed and
will be displayed on the drawing board only in order to facilitate operation.
The direction of cutting compensation can be selected manually. It can also be judged
automatically according to outer mold or inner mold. Outer mold needs outward compensation, while
inner mold needs inward compensation.
During the process of cutting compensation, you can select to translate the corner in the form of
round angle or right angle. As shown below:
In the figure the green is the original, the white is the compensated track, and the light yellow is
the vertical lines drawn from the corner. From the figure you can find that the cutting edges can
coincide with the original after both sides of the vertical lines are compensated, while the corner
needs transition. Usually round angle transition can ensure that the cutting edges can still coincide
with the original and run more smoothly during transition.
To facilitate the selection, you can edit the common compensation value in the general
configuration.
In order to clear compensation, please select the needed graphics, then click the button “Clear”
and choose “Clear Compensation”.
