11 CypCut Laser Cutting Control System
allow you to locate to the position you stopped last time; when click the button “
system will allow you to continue the processing from the position of last stopping.
”, the
II. Graphical Operation
CypCut provides the common drawing functions, which can be available easily from the drawing
toolbar on the left. The use of these functions is similar to AutoCAD mostly, and it is very intuitive.
Thus, this Manual will not introduce them in detail, if you have any questions, please feel free to
contact the customer service staff or Friendess Electron for help. We will introduce some special
graphical operations of CypCut as the software for laser cutting.
2.1 Graphical Display Effect
“View” in the first column under “Home” menu has multiple buttons which can help to control the
display effect, as shown below:
After you click the buttons in the figure above, the display will take effect immediately and then
you can find the changes in the display effect in the drawing board. Please pay attention to the display
changes of the buttons themselves, if the ground color is light yellow, it shows that the corresponding
effect has started; otherwise, it indicates that the display effect does not start yet. For example, in the
on- state “ ”, the arrow will show the graphical processing path in the drawing board; while in the
off state “ ”, the arrow will disappear.
When a graph is selected, by clicking the button “
”, the graph will be shown in the
center of the screen. If no graphs are chosen, please just click the button directly, and the whole
graphs will be displayed in the center.
