25 CypCut Laser Cutting Control System
The operation of “Sort in Group” will not change the graphical order of the sub-group within the
group. The order of “Sort in Group” only has the relations with the geometrical properties of the
graphics, while no relation with the layer to which it belongs. During the sorting, it will distinguish
inner and outer mold automatically according to the geometrical containing relations.
3.5.2 Processing of Group
The group (the part) will be considered as a whole during processing, and it will be finished by
continuous work. No other graphics will be inserted during processing. Even if the group (the part)
includes the graphics at multiple layers, it will be processed successively. Pre-piercing in group also
follows this rule.
Please note that no matter what the graphical order within the part is, the outer contour of the
part will always be processed finally. Please sort before processing.
3.6 Scanning
When the graphics to be cut are regular (such as rectangular, full circle, polygon) and possess a
certain regular arrangement, you can connect the cutting line segment with same direction by
scanning to conduct flight cutting, which will greatly improve the cutting speed and save cutting
time.
It recommends that users sort graphics needed to be scanned before scanning. This operation can
optimize the path of scanning and save move time.
Click "
" button under “Home” menu and then enter the fly cutting parameters setting
interface.
The starting position is to set the starting position of fly cutting. The minimum length of scan
line refers to the minimum segment length of actually cutting after fly cutting. If the segment length of
actually cutting after fly cutting is less than a given "minimum length of scan line ", the fly cutting does
not give any results, and prompt "It does not detect any curve to meet the fly cutting conditions." At
this case, it recommends increase the parameter value of "minimum length of scan line ".
