In place width
0.2
Servo Feedback delay
5
Height sensor delay
10
XC3000Series Motion Control System of Laser Cutting - User Manual
previous cycle (1ms ago) is greater than this value, the cutting head is
considered to have touched plate, and at this time the cutting head
moves upwards and starts the calibration to record the capacitance
value in relation to the height.
It refers to the range of height used to decide if the cutting head
follow-up is in place.
The delay can be auto-measured or adjusted by auto-tuning.
The delay can be auto-measured or adjusted by auto-tuning.
Parameter
Piercing delay
Cutting delay
Dry run delay
Default
200
100
50
Pre-touch-plate height 0.1
Edge follow
Disable
(to avoid touching plate)
Touch-Plate Parameter
Remark
In piercing, the system will alarm and stop cutting if the duration of the
touch-plate signal is greater than the value.
In cutting, the system will alarm and stop cutting if the duration of the
touch-plate signal is greater than the value.
When the cutting head is in a dry run, the system will alarm and stop
cutting if the duration of the touch-plate signal is greater than the
value.
If the current height is smaller then the value, it means the touch-plate
signal is triggered. The function is used to protect the value, so it is fine
to use the default value.
Enabled, once the cutting head is at the edge of the plate, it will
prevent the cutting head shaking and touching plate.
Parameter
Speed
Acceleration
Acc time
Default
1.8
5000
100
Axis Speed
Remark
The maximum speed limits the machine running. When the command
speed is faster than it, refer to this value. Generally, it calculates by the
max motor speed and pitch.
It refers to the acceleration in cutting.
The more the acceleration time, the slower the acceleration is, which
brings less impact to the machine. The less the time, the faster the
acceleration is, which brings more impact to the machine.
Parameter
Slow speed
Rapid speed
V1.0
Default
1.2
3
Jog Speed
Remark
It refers to the axis speed when it is controlled manually.
It refers to the axis speed when it is controlled manually in quick
mode.
Raytools AG © Copyright
www.raytools.ch
81 |87
