XC3000Series Motion Control System of Laser Cutting - User Manual
Traceless MicroJoint
Root Ratio
Leadline Process
Parameter
Slow Descent
Slow Descent
Focus Adjmt
Lead circle
Slag Removal Process
Nozzle height
Speed
Power
Cut freq
Duty cycle
Gas type
Gas pressure
Focus
Spot size
Radius
Cycle
Select to start using the traceless microjoint and make the thick plate not cut off at the joint
in processing.
Set the percentage of the retention left in cutting
Select to use the leadline.
Speed: set the cutting speed of graphic with leadlines.
Duty: set the beam-out duty cycle when laser cutting with leadlines.
Frequency: set the beam-out frequency when laser cutting with leadlines.
select to descent slowly when cutting with leadlines.
Lead height: set the nozzle height when cutting with leadlines.
Stable dist: slowly descent the leadline height to the stable height of the plate in cutting. Set
the stable distance of the leadline from the plate.
Focus Adjmt: select to use the focus adjustment of leadlines.
Focus point: set the focus position when cutting with leadlines.
Initial leadline: set the initial length of leadline of focus-adjust cutting.
Lead circle: select to use the lead circle.
Speed: set the processing speed of the lead circle.
Radius: set the radius of the lead circle.
Select to use the process to remove slags.
Set the cutting height from the nozzle to the plate when removing slags.
Set the cutting speed when removing slags.
Set the beam-out peak power of the laser when removing slags.
Set the beam-out frequency of the laser when removing slags. It refers to the time of beam
out in 1 second. The higher the value, the more continuous the laser beam is.
Set the beam-out duty cycle of the laser when removing slags. It refers to the ratio of
beam-out duration in one beam-out cycle and the total time. The higher the ratio value, the
higher the average power is when beam out. When it is 100%, the average power equals the
peak power.
Set the assist gas type when removing slags. There are the air, oxygen, and nitrogen.
Set the assist gas pressure when removing slags.
Set the focus position when removing slags.
Set the size of the laser beam when beam out in removing slags.
Set the radius of cutting nozzle when removing slags.
Set the Circle of cutting nozzle when removing slags.
3.10 Remark
Users can input some notes of the current process and other relevant information, like the nozzle size, according to the
needs in the Remark interface.
V1.0
Raytools AG © Copyright
57 |87
www.raytools.ch
    "