XC3000Series Motion Control System of Laser Cutting - User Manual
· Leadline: add to enable the workpiece to avoid being incomplete which may be caused by piercing.
· Start Point: set the start point of graphic processing.
· Micro Joint: insert small segments not to be cut in the graphic to avoid the part falling.
· Compensate: compensate the cutting slot.
· Reverse: set processing direction of the graphic (clockwise or anticlockwise).
· Cooling Point: protect the workpiece corners to be complete.
Change the processing layer of graphic.
(1) Select the graphic which needs to change a layer.
(2) There is a process bar on the right of the drawing area. Click on Layer buttons to complete the change of processing
layer. In the drawing area, colors of the layer can be used to distinguish them.
Click on Process button to set process parameters for the current graphic. Then click on OK, as shown below:
(1) Click on Process button and enter the setting page of process parameters.
(2) Select the sheet material and thickness.
(3) Set process parameters of the current graphic.
(4) Complete setting and click on OK.
V1.0
Raytools AG © Copyright
8 |87
www.raytools.ch
    "