Parameter
Gas on delay
First gas on delay
Pre gas on
Gas switch delay
Cooling delay time
Contour end closing
Contour end beam off
Default
200
400
500
200
1000
200
0
XC3000Series Motion Control System of Laser Cutting - User Manual
Default Parameter
Remark
Gas on and delay till the set time before laser on.
Before cutting, there are air in the gas hose. So, it takes a while for the
gas out before laser on to ensure stable cutting. Set the time of gas out.
It refers to the time to open the gas in advance after processing starts.
When switching to another type of gas in cutting, gas on first and gas off
delay before laser on and continue cutting.
Set the time of stay on the cooling point.
Set the delay of gas off at the end of cutting.
Set the delay of laser off at the end of cutting.
Parameter
Manual Air pressure
Manual Oxygen pressure
Manual Nitrogen pressure
Default
2
2
2
Use protective gas
Close
Protective gas pressure
Keep blowing
0.3
Close
Gas Parameter
Remark
the air pressure of manual gas out
the oxygen pressure of manual gas out
the Nitrogen pressure of manual gas out.
Open: open the protective gas and keep blowing once the system is
enabled.
Close: close the protective gas
Set the pressure of protective gas.
When it is open, keep the gas on when travel in cutting for a longer
lifespan of cover glasses.
Parameter
Unit of Length
Unit of Time
Unit of Speed
Unit of Acceleration
Unit of Gas pressure
Unit of Power rating
Default
mm
ms
m/min
mm/s^2
BAR
W
Unit Selection
Remark
“mm” and “inch” are available.
“ms” and “s” are available.
“m/min”, “mm/s”, “inch/min”, and “inch/s” are available.
“mm/s^2”, “inch/s^2”, and “G(10m)/s^2” are available.
“BAR”, “PSI” and “MPa” are available.
“W” and “%” are available.
V1.0
Raytools AG © Copyright
59 |87
www.raytools.ch
