4.2 Manual Control
XC3000Series Motion Control System of Laser Cutting - User Manual
：click on Mark to mark the current point as the cutting head position.
：click on Go Marker and the cutting head will move to the marked point.
：11 positions can be marked. Select the needed marked point in the drop-down bar.
：once the pin of the laser shutter connects to the system, click on Shutter to control the shutter switch.
：once the pin of the red laser light connects to the system, click on Aiming to control the red light.
：click on Laser to make the beam out to confirm the status of the laser beam. Set the laser parameters
by clicking on the drop-down bar on its right.
：click on Follow to bring the cutting head to a distance of 1mm from the plate. Click on Follow again to
cancel the following state and auto perform a Z-axis lifting.
V1.0
Raytools AG © Copyright
www.raytools.ch
67 |87
    "