Draw XC3000Series Motion Control System of Laser Cutting (Page 48 / 94) RAYCUT RayTools XC3000 Series Motion Control System of Laser Cutting User Manual

2.2 Draw

XC3000Series Motion Control System of Laser Cutting - User Manual

When drawing a graphic in the drawing area, there will be a prompt of next step in the log area.

User can complete the drawing with the prompt.

2.2.1 Line

Click on Line button in the Draw sub-page and click on the start point and next point in the drawing area with the prompt

in log to complete the drawing of a line.

Multiple lines can be drawn by continuously click on the next points. The end point of the line will be the start point of

the next one. Press Enter to complete the drawing.

2.2.2 Rectangle

Click on Rectangle button in the Draw sub-page and click in the drawing area to set the first corner. Click on another point

to set the other corner and complete the rectangle.

Click on the drop-down button under Rectangle button to get a drop-down bar which includes Rectangle, RoundRect, and

Obround. Click on RoundRect or Obround by the the prompt in log to draw the needed graphic.

The drawing can also be done by input a fixed size. Left-click in the drawing area to set the first corner. Then press D on

the keyboard and input the value of width and height with commas between them for separation. At last, press Enter to

complete the drawing. For example, “D50, 100” means 50 wide and 100 high.

2.2.3 Circle

Click on the drop-down button under Circle button in the Draw sub-page to see the drop-down bar which includes Circle,

3-Point Arc, Scan Arc, and Ellipse.

·Circle: click on Circle button and left-click in the drawing area to set the center. Then, input the radius by the keyboard.

At last, press Enter to complete.

·3-Point Arc: click on 3-Point Arc button. Click on three different points in the drawing area to complete the drawing.

·Scan Arc: click on Scan Arc button and click in the drawing area to set the center. Then, click on another point to set the

radius and drag to set the arc size.

·Ellipse: click on Ellipse button and click in the drawing area to set the center. Then, click on one point to set the vertex of

the short axis and another point to set the vertex of the long axis to complete drawing the ellipse.

It is suggested to use the Circle for drawing the graphics.

2.2.4 Polyline

Click on the drop-down button under Polyline button in Draw sub-page to see the drop-down bar which includes Polyline,

Polygon, and Star for drawing.

V1.0

41 |87