96 / 103 Friendess CypCut Laser Cutting Control System
3） The setting values of plate length and width are consistent with the actual
dimension.
4） The inclination angle of the steel plate should not exceed 40 degrees.
5） In test page it's available to customize a find edge position. But in actual
practice it must to set the reference position as top left, bottom left, top right
or bottom right so program can identify the find edge direction.
6） The first time use 3-point find edge function you have to measure the offset
in horizontal direction between switch and laser head center.
7） When execute find edge, you have to locate the guide laser within plate.
6.5 Regional Output
In CypCut config tool- Outport page you can set regional output for dusting.
Select 'Area output' set the lines and columns. Drag the boundary line can change the
area of each zone. You can assign output to each zone.
    "