76 / 103 Friendess CypCut Laser Cutting Control System
is calculated by the plate dimension, it's suggested that input value little smaller than
actual dimension to avoid laser head crash in machine teeth.
Margin: Find edge result will determine a 0 point of plate. This margin can
adjust the 0 point inward or outward the plate. If you have set plate margin in nesting
plate then you can input 0 here.
6-point find edge: This recommended to use on thin plate. Laser head will execute 6
times find edge actions to reduce the interference of machine teeth.
'From starting point'-you can set a fixed position then find edge will start from
this position every time. You can locate the laser head at a fit position as start point to
find edge. This position must be within the plate.
'From current position'-laser head will start find edge from current position.
Please make sure laser head is within the plate.
If select 'find edge before working', it will execute find edge before start machining.
Notice: Before execute find edge function, make sure laser head can follow to the
material properly. The inclination angle of the plate should not exceed 10 degrees.
Find edge parameter window shown as below.
