Friendess CypCut Laser Cutting Control System
6. Appendix
6.1 Co-edge Example
Below is a real example of a customer's part
graphic setting co-edge. The original DXF is on
the right side.
The graphic in red line is unclosed created in
CAD.
You can briefly tell that there are 6 bigger
parts and 10 long strip parts at bottom and 9*2=18
short strip parts at right side.
First, separate these 3 parts .As shown
below:
85 / 103
Then group the graphic as three single parts.
Select part 1 array in 3*2 pattern.
    "