FSCUT2000C laser cutting control system User Manual
40
3.5 Return to origin configuration
Forced open software limit: Enforce to open software limit function, and
prevent users from manually switching the software limit in the master interface of
CypCut.
Prompt user to return to origin after booting: Prompt the user to do the
operation of returning to the origin each time you open the software.
Return to origin in the way of alarm: Prompt the user to do the operation of
returning to the origin in the way of alarm each time you open the software.
ORG direction: Different type can select different rollback to origin direction.
Back to origin direction determines which quadrant tool coordinate is in. For example,
if X axis and Y axis select negative back to the origin, tool motion is in the first
quadrant.
ORG signal: if users select limitation signal, origin switch can be replaced by
limitation switch in the process of back to origin to realize coarse positioning.
Z direction signal: whether to use Z direction signal and sampled signal
determines specific process of back to origin. The system will show a whole process
on an image based on different back to origin way.
Fine speed: As shown in the green section of the figure, approach the origin
slowly and 10mm/s is recommended.
Coarse speed: As shown in the blue section of the figure, approach the origin
fast and 10mm/s is recommended.
Rollback distance: A distance for back in the motions of back to origin can
ensure distance of mechanical origin leaving a distance from position limit switch.
Limit switch logic: Set logic of X, Y, Z axis limit, and origin signal.
