25 FSCUT2000C laser cutting control system User Manual
When BCL3766 External IO Board is selected, besides 8 relay outputs, there are also
12 mosfet outputs, which can directly drive 24V direct current device.
2.3.7 Analog output
DA1 and DA2 are 2 outputs of 0~10V analog signal. DA1 and DA2 can be
configured as a control signal of controlling the laser peak power and proportional valve
through “platform configuration tool” coming with the CypCut software.
2.3.8 PWM output
When the laser type is configured as “fiber laser” through “platform configuration
tool” coming with the software, PWM output port will be activated and used for
controlling fiber laser average power.
When PWM is controlled needing to use 5V, 1 pin of four bit dip switch is OFF,
and 2 pin of four-bit dip switch is ON; Optionally select one among 3 pin and 4 pin is
ON, then another one is OFF.
When PWM is controlled needing to use 24V, 1 pin of four bit dip switch is ON,
and 2 pin of four bit dip switch is OFF; Optionally select one among 3 pin and 4 pin is
ON, then another one is OFF.
    "