Friendess CypOne Laser Cutting Control Software
52
laser and gas configuration. The parameter in demonstration image is only for
reference.
3.12.1 Parameter Description
The following table gives a brief description to some of the layer parameters.
① Basic parameters
Cut speed
The target/command cutting speed, while the actual
cutting speed is under this value considering the speed
change in corner turning, or in start and end phase in a tool
path segment.
Lift height
After finish a tool path segment, laser head lifts and
locates to next start point of tool path segment. When pause
the cutting, laser head also lifts and holds to this height.
Nozzle height
②Cutting parameters
The standoff distance between nozzle and plate surface
in cutting.
Gas type
Gas type in cutting.
Gas pressure
Gas pressure in cutting. Pressure regulation requires DA
gas valve signal given by CypOne.
Peak power
The peak power decides the maximum power in cutting.
Take an example,3000W laser source, peak power set by
80%, the maximum power in cutting is 3000 * 80% =2400W.
Duty cycle
The duty cycle of PWM laser modulation signal in
cutting. 3000W laser, peak power 80%, duty cycle 80%, the
average cutting power is 3000*80%*80%=1920W.
Pulse frequency
The pulse frequency of PWM modulation signal, it
    "