Error
code
Module
Type
Brief Description
波形点模式超出最大范围
03013 Warning Warning Type Waveform point mode exceeds
maximum range
Error Description
Recommended measures
可能1.波形数据不正确或被破坏
可能2.固件参数不正确或被破坏
可能3.系统波形数据与当前喷车板不匹配
Possible 1. The waveform data is incorrect or
damaged.
Possible 2. The firmware parameters are incorrect
or damaged.
Possible 3. The system waveform data does not
match the current trolley board.
1.重新导入正确的固件配置文件和固件参数文件。
2.导入正确的波形文件。
1. Re-import the correct firmware configuration file and firmware parameter file.
2. Import the correct waveform file.
03014 Warning
Warning Type
执行打印任务前小车运动的距离
超过了X白边位置
The distance the carriage moves
before executing the printing task
exceeds the X white edge position
可能1.打印前小车位置和X白边位置不一致
Possible 1. The carriage position and the X white
edge position are inconsistent before printing
1.请确保小车加速距离小于X白边位置
Make sure the trolley's acceleration distance is less than the X white edge position
03015 Warning
Warning Type
执行打印任务前小车运动的距离
超过了Y白边位置
The distance the carriage moves
before executing the printing task
exceeds the Y white edge position
可能1.打印前小车位置和Y白边位置不一致
Possible 1. The carriage position and the Y white
edge position are inconsistent before printing
1.请确保小车加速距离小于Y白边位置
Make sure the trolley's acceleration distance is less than the Y white edge position
参数异常，X齿轮比小于0
可能1.参数异常，X齿轮比小于0
1.请在厂家模式界面检查齿轮比的参数值是否填写错误
03016 Warning Warning Type Parameter abnormality, X gear ratio Possible 1. Parameter abnormality, X gear ratio is Please check whether the gear ratio parameter value is filled in correctly in the
is less than 0
less than 0
manufacturer mode interface.
闪喷槽参数设置错误
03017 Warning Warning Type Flash spray tank parameter setting
error
可能1.闪喷槽宽度设置不正确
可能2.闪喷槽距离设置不正确
Possible 1. The width of the flash spray slot is not
set correctly
Possible 2. The distance of the flash spray slot is
not set correctly
1.检查闪喷槽宽度参数设置是否正确
2.检查闪喷槽距离参数设置是否正确
1. Check whether the flash spray slot width parameter setting is correct
2. Check whether the flash spray slot distance parameter setting is correct
