Error
code
Module
13041 Error
Type
Brief Description
Error Description
Software type
打印失败，下1PASS小车起始位 可能1.光栅异常
置异常
可能2.齿轮比异常
Printing failed, the starting position Possible 1. Grating abnormality
of the next 1PASS car is abnormal Possible 2. Gear ratio abnormality
13042 Error
Software type 墨栈下降超时!
Ink stack drop timeout!
可能1.墨栈马达异常
可能2.墨栈限位异常
Possible 1. Abnormality of ink stack motor
Possible 2. Abnormality of ink stack limit
Recommended measures
1.检查光栅读取是否存在异常
2.确认齿轮比是否存在异常
1. Check if there is any abnormality in the grating reading
2. Check if there is any abnormality in the gear ratio
1.检查墨栈马达是否正常
2.检查墨栈限位是否正常
1. Check whether the ink stack motor is normal
2. Check whether the ink stack limit is normal
13043 Error
Software type 墨栈上升超时!
Ink stack rise timeout!
可能1.墨栈马达异常
可能2.墨栈限位异常
Possible 1. Abnormality of ink stack motor
Possible 2. Abnormality of ink stack limit
1.检查墨栈马达是否正常
2.检查墨栈限位是否正常
1. Check whether the ink stack motor is normal
2. Check whether the ink stack limit is normal
13044 Error
等待马达停止超时
可能1.固件配置的参数时间太短
Software type Waiting for the motor to stop timed Possible 1. The parameter time of the firmware
out
configuration is too short
1.导入正确的固件配置和参数
Import the correct firmware configuration and parameters
13045 Error
Software type
可能1.抽残墨动作执行失败
可能2.固件配置或固件参数不正确或被破坏
可能3.固件参数和固件配置不匹配
执行自动闪喷抽残墨动作失败 Possible 1. The residual ink extraction action
Failed to execute the automatic flash failed.
jet to extract residual ink
Possible 2. The firmware configuration or
firmware parameters are incorrect or damaged.
1.检查设备墨栈运动是否正常
2.重新导入正确的固件配置文件和固件参数文件
1. Check whether the ink stack of the device is moving normally
2. Re-import the correct firmware configuration file and firmware parameter file
Possible 3. The firmware parameters and firmware
configuration do not match.
13046 Error
等待停止信号超时
Software type Timeout waiting for stop signal
可能1.固件配置的参数时间太短
Possible 1. The parameter time of the firmware
configuration is too short
1.导入正确的固件配置和参数
Import the correct firmware configuration and parameters
    "