Error
code
Module
Type
Brief Description
10000
Error
PASS参数传输异常
Communication PASS parameter transmission
abnormality
关闭闪喷失败
10001 Error Communication Failure to turn off flash spray
Error Description
Recommended measures
可能1.软件程序和主板程序版本不匹配
可能2.打印软件与主板程序通讯异常
Possible 1. The software program and the
mainboard program version do not match Possible
2. The printing software and the mainboard
program communicate abnormally
1.软件版本Information里查看软件和主板程序的前四位版本号是否相等。
2.通过软件左下角的连接状态图，检查设备是否连接正常。
1. Check the first four digits of the software and mainboard program version numbers in
the software version information to see if they are the same.
2. Check the connection status diagram in the lower left corner of the software to see if
the device is connected properly.
可能1.主板与喷车板光纤连接失败
可能2.主板或喷车板光纤模块异常
可能3.喷车板电源异常
Possible 1. The optical fiber connection between
1.更换新的光纤线，连接测试。
2.更换光纤模块测试。
3.检查喷车板电源电压是否符合标准需求。
the mainboard and the trolley board failed.
1. Replace the new optical fiber cable and test the connection.
Possible 2. The optical fiber module of the
2. Replace the optical fiber module and test.
mainboard or the trolley board is abnormal.
3. Check whether the power supply voltage of the trolley board meets the standard
Possible 3. The power supply of the trolley board is requirements.
abnormal.
10002
Error
加载系统参数失败
Communication Failure to load the system
parameters
喷车板复位失败
10003 Error Communication Head board reset failed
可能1.软件程序和主板程序版本不匹配
可能2.打印软件与主板程序通讯异常
Possible 1. The software program and the
mainboard program version do not match
Possible 2. The printing software and the
mainboard program communicate abnormally
1.软件版本Information里查看软件和主板程序的前四位版本号是否相等。
2.通过软件左下角的连接状态图，检查设备是否连接正常。
1. Check the first four digits of the software and mainboard program version numbers in
the software version information to see if they are the same.
2. Check the connection status diagram in the lower left corner of the software to see if
the device is connected properly.
可能1.主板与喷车板通讯异常
Possible 1. Abnormal communication between the
mainboard and the trolley board
1.更换新的光纤线，连接测试。
2.更换光纤模块测试。
3.检查喷车板电源电压是否符合标准需求。
1. Replace the new optical fiber cable and test the connection.
2. Replace the optical fiber module and test.
3. Check whether the power supply voltage of the trolley board meets the standard
requirements.
    "