Operation Manual of WEICHAI GENSET
Stop
6020MKII
Select the Stop/Reset
mode, and the set will
stop running
7320MKII
stopping sequence in the AUTO mode
starts.
2. Test mode
In the test mode , the set will stop
running in following cases:
Press the Stop/Reset button – the delay
load output will be invalid, and the set
will stop running immediately.
Press the AUTO mode button, The set
can monitor all start orders in the AUTO
mode and stop the timer before the
stopping sequence in the AUTO mode
starts.
3. Auto mode
The return delay timer runs to ensure
that the start request is completely
cancelled instead of being cancelled for
a short time. If there is a start request at
the cooling down and stop stage, the set
will be reloaded.
Select the Stop/Reset
mode, and the set will
stop running
1. Manual mode
In the manual mode , the set will
stop running in following cases:
Press the Stop/Reset button – the delay
load output will be released immediately,
and the set will stop running
immediately.
Press the AUTO mode button, The set
can monitor all start orders in the AUTO
mode and stop the timer before the
If no start request is sent any more at the
end of the return delay stage, the circuit
breaker will be disconnected after the
generator set is unloaded, and the
generator set will initially cool down and
stop.
With the cooling timer, it is allowed that
the alternator removes its load and fully
cools down before shutdown. This is
especially important when the engine is
equipped with a turbocharger.
The set will stop running after the delay
of cooling timer.
Caution! Before shutting down the set,
you must turn off the switch for
unloading. It is strictly forbidden to shut
21
