EzCad2UNI User’s Manual
Speed of Go Zero: The move speed when expansion axis go zero.
Zero time out: The system will present “Zero time out” when failed to reach the position
where the zero switcher was assembled within the appointed time.
Accurate Zero：When it is selected, the axis must gives three zero signals in go zero process;
and it isn’t selected, the axis only need one signal.
Correct axis origin: The current expansion axis go zero and reset coordinates.
The following example explains how to use this module.
Requirement: Mark three letters a 、 b 、 c on the surface of a column, the angle intervals
between two adjacent letters is thirty degree.
Step 1: Draw letter a in workspace. Set coordinate Z to 0 and click Apply button. Click put
to origin button on toolbar to put the letter a to the center of workspace. As is shown in Figure
85-1.
Figure8-5-1 setting of letter a
Figure8-5-2 setting letter b
Figure8-7-3 setting of letter c
Step 2: Draw letter b in workspace similarly. Set coordinate Z to 30. Then click Apply button and
click put to origin button, as is shown in Figure 8-5-2.
Step 3: Draw letter c in workspace and set coordinate Z to 60. Then click Apply button and click
put to origin button. As is shown in Figure 8-5-3.
Step 4: Click menu item Rotary marking. The dialog box shown in below Figure 8-5-4 will
popup.
95
All rights reserved
