EzCad2UNI User’s Manual
where the zero switcher was assembled within the appointed time.
Correct axis origin: The current expansion axis go zero and reset coordinates.
The following example explains how to use this module.
Requirement: Mark three letters a、b、c on the surface of a column, the angle intervals
between two adjacent letters is thirty degree.
Step 1: Draw letter a in workspace. Set coordinate Z to 0 and click Apply button. Click put
to origin button on toolbar to put the letter a to the center of workspace. As is shown in Figure
85-1.
Figure8-5-1 setting of letter a
Figure8-5-2 setting letter b
Figure8-7-3 setting of letter c
Step 2: Draw letter b in workspace similarly. Set coordinate Z to 30. Then click Apply button and
click put to origin button, as is shown in Figure 8-5-2.
Step 3: Draw letter c in workspace and set coordinate Z to 60. Then click Apply button and click
put to origin button. As is shown in Figure 8-5-3.
Step 4: Click menu item Rotary marking. The dialog box shown in below Figure 8-5-4 will
popup.
87
All rights reserved
    "