XC3000S Series Laser Cutting
System Commissioning Manual
3) Servo driver control signal wiring diagram.
The following items should be noted when connecting the servo drive:
The EDS2000 uses a pulse + direction signal to control the servo drive, and you must confirm that the drive
supports this mode.
Confirm the selected type of Servo Drive Enable Signal (SON) is active low (ON when conducting with
24V power ground).
Confirm the selected type of Servo Drive alarm signal (ALM) is active low (ON when conducting with 24V
power ground).
Confirm the servo drive parameters are set correctly. If the servo cannot run, the parameters should be set to
"Forward and reverse input disable". The F-axis servo interface is an open-loop control interface and does
not support encoder signal input.
Wiring with Yaskawa, HCFA, Panasonic, Delta B series & A2 series, and Fuji servo drives, please refer to
the following wiring diagram.
If you have any questions, please consult our technical professionals.
147
    "