XC3000S Series Laser Cutting
System Commissioning Manual
Note: EDS3000 board ALM signals are active low, which can be switched to active high by the jumper cap
next to the corresponding axis port. The alarm polarity of the axis port can also be set in the configuration
tool to change the alarm trigger conditions.
2. Servo drive control signal wiring diagram
Note: The following should be noted when connecting the servo drive:
EDS3000 uses a pulse + direction signal to control the servo drive, and it must be confirmed that the drive
supports this mode; and whether the type of servo drive enable signal (SON) selected is active low;
Confirm the servo drive parameters are set correctly. If the servo cannot run, the parameters should be set
to not use the "forward and reverse input prohibition";
31
