Z-axis middle limit logic
XC3000S Series Laser Cutting
System Commissioning Manual
Not used,
When the upper table is in the cutting area, Z-axis
NC
hardware limit logic (different from Z- limit; it can
be considered that Z-limit is the negative limit of the
lower table and this limit is the negative limit of the
upper table) can be set in hard limit input pins
Forward in-pos signal reached
pallet
Up-pallet
Cylinder only output after the
pallet is in place.
Unchecked
Fill in the actual configuration, it will determine
which table is currently in the cutting area, based on
this parameter.
Check the box according to the actual
situation
92
    "