XC3000S Series Laser Cutting
System Commissioning Manual
Up-row unclamped in-pos login Not used
Settable top-row loose-in-place input pin
NC
The output logic of the upper table fixed cylinder
opening in place sensor
Up-row clamped in-pos login Not used
NC
Settable top row clamping in place input pins
The output logic of the upper table fixed cylinder
clamping in place sensor
Lower-row unclamped in-pos Not used
login
NC
Settable lower row release in place input pins
output logic of the lower table fixed cylinder
opening in place sensor
Lower row clamped in-pos login Not used
NC
Cylinder unclamped in-pos signalNot used
None
Cylinder clamped in-pos signal Not used
None
Dual pallet use one cylinder Close
Jog/Auto mode switch
Use IO
Settable lower row clamping in place input pins
The output logic of the lower table fixed cylinder
clamping in place sensor
Settable cylinder release in place pin
Fill in the actual configuration; if you choose
none, after the signal output, it will wait for the
time to fill in (wait for the cylinder to open
completely), and then move the pallet changer.
Fill in according to the actual configuration
Settable ON or OFF
Use IO: use external signal to switch between
manual and automatic modes
Paller changer with bolt
No
Use HMI: use the software interface to switch
between manual and automatic modes
Fill in according to the actual configuration
92
