appropriate delay parameter can remove the "match head" at the beginning of
marking, but if the delay parameter setting is too large, it will lead to the lack of
pen at the beginning. It can be a negative value, which means that the laser
light comes out ahead of time.
Laser Off TC Delay time for laser OFF at the end of marking. The proper
Laser Off TC parameters set can eliminate the misclosure phenomenon
appears at the end of marking, while the too large ones may cause “watch
head” appears at the termination segment. This value cannot be negative.
Off light delay: Delay time for laser off at the end of marking. Setting the
appropriate light off delay parameter can remove the non closing phenomenon
when the marking is completed, but if the light off delay setting is too large, the
end segment will appear "match head". Cannot be negative.
End TC: Generally, there is a period of response time from sending laser OFF
command to completely laser OFF, proper End TC is set to provide the laser
with sufficient response time for laser OFF, so as to make the laser perform
next marking in case of totally OFF to prevent light leakage and point dragging.
End delay: Generally, it takes a period of response time from the time when
the light off command is sent to the time when the laser is completely shut
down. Setting an appropriate end delay is to give the laser a sufficient light off
response time, so as to achieve the purpose of making the laser carry out the
next marking when the laser is completely shut down, and prevent the light
from leaking and the phenomenon of point rejection.
Polygon TC: Delay time between each segment during the marking. The
proper Polygon TC parameters set can eliminate the circular angle appears
during right angle marking, while the too large ones may cause marking time
increase and double points at the corner.
Corner delay: Delay time between each segment during marking. If the corner
delay is set too much, the marking time will increase, and the corner will have
the key phenomenon.
:
164 / 217
