RDC633xM Specification
Press the down key, will move to the direction of the platform.
l Press automatic search for surface, the cutting head move to the direction of platform with low speed.
Until meet with the platform, the direction move to focus position and stop.
l At this time, can be tested by RDC6332M, in RDC6332M standby mode, press the "." (Decimal
point) on the panel, the cutting head is reduced to the focus position, press again, the cutting head lift
up.
l If all above operation are normal, you can perform a cutting task.
6 Interface with au3Tech FTC6105
RuiDa Technology Co.,Ltd
1B,Building 5,Nanyou Tian’an Industry zone,Nanshan District,Shenzhen
TEL: 0755-26066687
E-Mail: support@rd-acs.com
Web: www.rd-acs.com
FAX: 0755-26982287
    "