S/N
Question
Inspection direction
Solution
Please check whether the emergency shutdown switch is Please rotate the button to turn on the
pressed.
emergency shutdown switch.
Please check whether the pedal control button is pressed.
Please press the pedal control button
again, and the indicator light is off.
The simple
panel displays
content, but the
Please check whether the output of switching power
supply is less than 24V.
Please change the switching power
supply.
rubber roller Please check whether the emergency shutdown switch is Please change the emergency shutdown
1 doesn't work.
damaged.
switch.
Please check whether the circuit is loose.
Please determine the loose part and
screw down it.
Please check whether the set temperature is lower than
the indoor temperature.
Please reset the temperature.
Please check whether the temperature control probe is Please change the temperature control
damaged.
probe.
2
The equipment
can't heat up.
Please check whether the temperature switch is
damaged.
Please check whether the quartz pipe is damaged.
Please change the temperature switch.
Please change the quartz pipe.
3 Overheating
The temperature control probe is damaged.
Please change the temperature control
probe.
Please check whether the rubber roller is worn down.
Please burnish the rubber roller.
Please check whether the tightening force of the picture
placing core axle is adjustable.
Please change the friction plate.
4
Displacement of Please check whether the friction plate is worn down.
laminating Please check the axle and bearing in components of
aluminum heads of the picture placing core axle.
Please change the aluminum head.
Please check whether slipping appears.
Please check whether the rubber roller is damaged.
The laminated
5 film is creased. Please check whether the left and right supports of the
picture placing core axle is tightly installed.
Please burnish the rubber roller.
Please install the parts again.
Please check whether the rubber roller is damaged.
The laminated
6
film has
bubbles.
Please check whether the value shown by the air gauge
is lower than 0.2Mpa.
Please burnish the rubber roller.
Please adjust it to 0.3Mpa.
Please check whether the friction plate at the end of the
film placing core axle is worn down.
Please change the friction plate.
The lining paper
7
can't be folded.
Please check whether the chain wheel and the long axis
are clamped tightly at the end of the lining paper
collecting core axle.
Please change the chain wheel and the
long axis.
9
    "