Wiring and Connection 2 Wiring and Connection 21 Servo (Page 15 / 380) L7P INDEXER Series AC Servo User Manual

2. Wiring and Connection

2.1 Servo Motor Installation

2.1.1 User Environment Requirement

Items

Surrounding

Temerature

Surrouding

Humidity

External

Vibration

Environment Requirements

0 ∼ 40[℃]

80[%]RH or below

Vibration Acceleration

X, Y direction / 19.6[㎨] or below

Notes

When the temperature exceeds the workable

temperature, a separate command must be placed after

consulting with the Tech Department

Please use the product where no steam is generated

Excessive vibration may shorten the life cycle of the

bearings

2.1.2 Preventing Excessive Impact

Excessive impact on the motor during installation or accidental fall may destroy the encoder.

Caution

2.1.3 Wiring with Motor

Directly connecting the motor with commercial power damages the motor. Please use the

designated drive to connect power.

Please connect the earthing terminal of the motor to one of the two earthing terminals of the drive,

and connect the other terminal with a Type-3 ground connection.

U – U

V - V

W – W

- F.G

Please match the U, V, W terminals of the motor with the U, V, W terminals of the drive.

Please check the motor connector for any missing pin or bad contact.

If the motor has humidity or condensation, please check if the insulation resistance is 10[㏁] or

more (500[V]), and install the product only when there is no problem.

2-1