First, Last or
Both
Sets additional
Stepdown values
for First, Last or
Both passes. You
can specify how
deeply you want
the tool to
engrave on each
pass.
Clearance
Sets the amount of space the tool
lifts between paths.
3 Click OK.
Engraver Driver Options
Engraver Driver Options allow you to set parameters for your output
device.
You can change the values so that the settings will be sent to the output
device, overriding the settings in the output device.
Before Job
After Job
Defines commands that will be sent before the job is
processed.
Defines commands that will be sent after the job is processed.
Macro
Save
Allows you to execute common tasks that you are usually
required to do from the engravers control panel.
Saves the changes you made as a new command.
Delete
Reset
XY Velocity
Deletes the selected command from the list. You can only
delete commands that were added using the Save command.
Reverts all settings to the default settings. Any custom
commands you add will be deleted.
Speed at which tool engraves material.
Z Velocity
Speed at which tool lifts and lowers.
Spindle RPM The speed at which the spindle rotates.
Dwell-time
Motor Control
Amount of time engraver pauses before changing path
direction.
Turns engraver motor on and off.
Start Delay
Delay before engraver begins engraving.
Engraving
speed
Speed at which tool engraves material.
Spindle Motor Turns engraver motor on and off.
Keep clear of the output device when sending the macros, since the engraver
may move and injure the operator.
Before Job tab
After Job tab
Macro tab
© 2006 SA International
164
