evenly.So the minimum power the speed of the corresponding minimum energy, the minimum
speed general is 0, but if set the speed is the minimum speed for takeoff take-off speed; The
maximum power correspond to the layer speed.
Set minimum power, and the most high power flow:
1> The minimum power and the maximum power set to the same value, synchronous
adjustment. Until all the cutting curve are already appear.
2> The maximum power unchanged, and gradually reduce the minimum power until the
energy of the heavy cutting curve at the lowest level, and all of the cohesion parts can be
processed to come out.
3>If not yet to best effect, can be the most appropriate fine-tuning high power, and repeat
step 2.
If is cut through, the minimum power loss and the maximum power no significant difference,
can be set to give the same.
To scan processing, ordinary scanning, the minimum power and the maximum power must be
consistent. Slope sculpture, minimum power loss is the power of the corresponding factors, the
most power is the power of the bottom of the corresponding.
top
Bottom
Minimum power loss is the top for the small slant wide, detail place distinguish clearly.
Minimum power loss is too large slope not obvious.
To fix processing, the minimum power and the maximum power can be set to agree.
If checked "default", the actual power panel set by the power to determine.
Click the button "advanced", but also can be set to other layer parameters.
【 Pen up and down 】 If machines have installed the lift platform, and need to be in a different
