Shenzhen RelFar Intelligent Technology Co., Ltd.
21
The marking point is
on this page
Chapter 10 Processing Module Switching
10.1 Selection of processing type
As for the welding mode switching to 100mm cleaning mode,
inputting password-666666 will be reminded by clicking
[Processing Type] on the panel pursuant to [System
Parameter]->[Authorization]->[Processing Type]. After the
password is put correctly, enter the system type selection
interface, as shown in the figure:
Select the type of equipment to
be replaced:
Welding
system
Energy storage
welding
Cleaning-100mm
Cleaning-300mm
Cancel
10.2 Hint of module replacement
After the user chooses the processing type, the system shall use the
33
    "