DZB100 Series
Installation and Wiring
Chapter 2 Installation and Wiring
Chapter 2 provides the information needed to properly install and wire the AC drive.
Make sure that the AC drive is wired according to the instructions contained in this chapter.
The instructions should be read and understood before the actual installation begins.
2.1 Installation Requirements
2.2 Wiring
2.3 Basic Wiring Diagram
2.1 Installation Requirements
Install the AC drive vertically to provide proper ventilation. Adequate space isrequired between
the drive and a wall or other equipment. The figure below shows the minimum space needed.
All enclosures must provide adequate ventilation and the internal ambient temperature
must be kept at 40 or below.
AIR
Wiring orifice
FWD
REV
JOG
RUN
PRGM
RESET
FUNC
DATA
STOP
AIR
Caution: The AC drive should be installed in an environment that is:
1.protected from rain or moisture;
2.protected from direct sunlight;
3.protected from corrosive gases or liquids;
4.free from airborne dust or metallic particles;
5.free from vibration;
6.free from magnetic noise
7.temperature: -10 C to +40 C; R.H.: 0% to 90%; air pressure: 86kPa to 106 kPa
-5-
