Ioline SmarTrac Contour Cutters
To cut a contour using Ioline registration marks:
1. Print the job and load the printed output into the cutter.
2. Send the cut job.
Dial the cutting speed down when aligning on the marks to make it easy to
control. Dial the speed back up again to cut.
The cutter will automatically find the other registration
marks.
4. Click Yes to cut the contour.
If the cutter does not automatically find the registration marks,
click No to abort the job.
3. Align the sensor light over the first mark (the lower right
mark), press the Set Origin button on the cutter, and then
click OK in the software.
© 2006 Scanvec Amiable, Inc.
16
