erber GS15 HS15 HS15 Plus HS750 HS750 Plus To cut a (Page 13 / 27) Contour Cutting Guide

Gerber GS15, HS-15, HS-15 Plus, HS-750, HS-750

Plus

To cut a contour using a Gerber cutter:

1. Add a setup for the cutter to PhotoPRINT or Production

Manager.

2. Depending on the application, do the following:

• In PhotoPRINT, add the job and open Job Properties.

• In Flexi, design the job and open the RIP and Print

dialog.

3. Set Registration Mark to Gerber Edge Center.

4. Print the job and load the printed output into the cutter.

5. Send the cut job.

7. Press the RUN/START JOB button on the cutting device

(or Run Single, etc.).

8. Click on OK in the software.

The cutter will detect the registration mark, and then cut the

contours.

6. Use the front panel controls on the cutter to position the

head of the cutting device over the Gerber registration

mark.