Laser Engraving & Cutting Control System Manual
40.384001 in the picture above means the distance of the laser head moves every round of the
motor is 40.384001 mm. 6400 is the pulse every round of the motor needs.
Pulse unit can be set by measuring. Click “Measure”and dialog box appears as below:
As the above picture indicate, draw a line in the software that the length is 100mm and cut.
Measure the work piece and the actual length of the line is 90mm, and input the value, the system
will calculate the pulse unit automatically.
3.7.1.3 Home/Datum Dir
Right of the X-Axis and upside of the Y-Axis are positive direction. Ensure the
correspondence of the switch position on the original point and the setting of this option.
3.7.1.4 Home/Datum Offset
After datum, the laser head will move a distance along the reverse direction of the origin
switch.
3.7.1.5 Home/Datum Speed
Speed of the laser head going back to the original point. It should not be too large, or the
switch of the original point may be damaged.
3.7.1.6 Slow Jog Speed
Test speed of the laser head, when “Auto datum”is not been chosen.
3.7.1.7 Fast Jog Speed
Test speed of the laser head, when “Auto datum”is been chosen.
3.7.1.8 Jog Acceleration
It is the acceleration from start speed to jog speed.
3.7.1.9 Max Change Speed
It is the maximum speed of changing direction of the X or Y axis. The smaller the value is,
the better the quality is, but the lower efficiency of the processing is.
3.7.1.10 Backlash
It is used to compensate the backlash in cutting.
3.7.1.11 Z-Axis
Z-axis should be enabled. Z-axis can be used as auxiliary head of 2-Head machine, feeding
34
