Laser Engraving & Cutting Control System Manual
Corner Power1/2: adjust power of laser head when the speed is the minimum in the variable
speed motion.
(Adjustment of the power and corner power can ensure an unchanged strength of the laser in
the process).
Overlap Length: closed graph may not to be cut down due to the mechanical error. This
parameter helps to solve the problem, but it should not be too large. It is suggest to adjust
mechanical assemble precision to solve the problem.
Blow mode:
Not Blow: not to blow in the process.
Cut Blow: blow when laser on, stop blowing when laser off. This function needs hardware
support.
Always blow: blow at the moment laser head begins to move, and close at the end of the
process. This function needs hardware support.
Flying Cut: select this option and the system will cut with fast mode.
Flying Cut Mode:
Dotted Line: cut the line to dotted line. 1,-1 descript the dotted line.
Jump for Fast: this mode can increase cutting efficiency and quality, but it is only useful when
the graph processed by “Part Virtual Array”.
Layer Times: a layer can be processed many times. Input the value as you need.
Delay before laser on: set the delay before the laser is on
26
