CAUTION:
1. For continued protection against fire, disconnect the power-supply before using the machine. Check that
the power supply has a grounded connection before using.
2. Disconnect the power supply before replacing with a different-function heat unit.
3. Put in the object that is to be shaped, close the pressure handle and
rotate the adjusting screw to get the proper pressure.
4. The surface of the heat unit is hot during heat pressing. Do not touch the surface without proper
protection.
BASIC PREPARATION BEFORE USING:
1. Plug the three-core power line into the outlet. Check whether the power
supply is conformity with the rated voltage of the machine; there should be a reliable ground wire for the
power supply.
2. Put in the object which is going to be shaped, close the handle and rotate the
adjusting screw to get the proper pressure (The pressure of the mug press unit is a screw.)
3. Turn on the power switch. The instrument board will display the current set temperature.
4. Set the temperature and time according to the table below and make use of the corresponding
temperature and timing settings.
Object
Initial Temperature
Highest Temperature Time
Mugs
230
330
40 seconds
Tiles
230
330
40 seconds
Metal board
230
300
40 seconds
Plate
355
355
150 seconds
T-shirt
355
355
Sublimation paper
30-50 seconds
T-shirt paper
10-20 seconds
Learn to set the temperature and time:
